When removing the Screw after cleaning

  1. 1

    End leading product processing

    Remove the preceding resin from the hopper and drain into a cylinder.

  2. 2

    Preparations

    Removal may be easier at a lower temperature depending on the type of resin used.

    The hopper should be cleaned thoroughly.

  3. 3

    Load the Z CLEAN™

  4. 4

    Purge with Z CLEAN™

    Raise the speed of the auger and confirm the in load on the motor and the resin pressure.

    The penetration of the surfactant and the cleaning effect can be improved by allowing a soak (5-10 minutes).

  5. 5

    Discharge the Z CLEAN™.

    Completely drain the Z CLEAN™ from the machine and die.

  6. 6

    Remove, disassemble and clean the auger